TOHATSU EverRun MX 18E2 Service Manual page 216

Power Unit
6 6
2st
2st OIL 2st OIL
6 6
5 5
6 6
7 7
5-64
5 5
3 3
a a
3. Installation of Piston Pin
1) Attach piston pin 5 to special tool 6, and apply two
stroke engine oil. Place the piston to small end of
connecting rod, and then insert piston pin with special
tool 6 into them.
Piston Pin Tool 6 :
P/N. 3LD-72215-0
· Assemble the parts so that the side marked with
"UP" on the piston head faces flywheel side.
· When a new piston is used, apply molybdenum
grease (Moly-paste 500) to piston pin hole and
two-stroke engine oil to piston pin.
2st OIL
2st
2) Press out special tool from the piston, and then attach
piston pin clip 6 to the piston.
3) Fit piston pin clip 7 as shown.
Take care not to scratch to piston wall,
when fit piston pin clip.
Set the piston pin clip so that the gap of the clip is
at the opposite side of the opening a located in
the piston pin clip groove.
CAUTION
2st X18E2 2012
GB