Add The Lamp Information To The Lamp History; Turn The Lamp On; Align The Lamp - Christie Solaria One User Manual

Field
Apply
Serial Speed (Baud)
Enable SNMP
SNMP V2 / SNMP V3
Management IP
Download MIB to USB
Apply
Serial Access
Ethernet Access
1.16

Add the Lamp Information to the Lamp History

1. If the lamp is on, tap the lamp off (
2. Tap Menu > Advanced Setup > Lamp Change Wizard.
3. Tap Next.
4. Complete these fields:
Field
Type
Serial Number
Reason for Change
Lamp Expiry (Hours)
Hours Used
5. Tap Save.
6. Tap Next.
1.17

Turn the Lamp On

On the projector touch panel controller (TPC) tap the lamp on(
1.18

Align the Lamp

1. Tap Menu > Advanced Setup > Lamp Power.
2. Verify the value in the Power% field is at a level suitable for your requirements.
3. Tap Menu > Advanced Setup > Light Adjust.
4. Record the number in the Intensity field.
5. Tap Display Full Screen White Test Pattern.
6. Complete a coarse lamp adjustment:
1-18
Description
Applies Ethernet settings.
The baud rate of the serial port. The default is 115200.
Enables SNMP.
The SNMP protocol type. Contact Christie for the SNMP V3 user ID and password.
The IP address where SNMP information and notifications are sent.
Sends the SNMP Management Information Base (MIB) file to a USB flash drive.
Applies SNMP settings.
Grants access to serial connections.
Grants access to Ethernet connections.
) icon to turn it off.
Description
The lamp type.
The lamp serial number.
The reason the lamp was changed.
The number of hours the lamp can operate before replacement. This field
is auto-populated.
The number of hours the lamp has operated before installation.
) icon.
Solaria One User Manual
020-100841-02 Rev. 1 (11-2012)