Install The Lamp - Christie Solaria One User Manual

6. Insert and tighten the two lens mount hex screws shipped separately with the projector.
7. Lock the lens assembly in place with a hex key.
8. Replace the lens surround.
1.9

Install the Lamp

DANGER
High-pressure lamp may explode if improperly handled. Always wear approved protective
safety clothing whenever the lamp door is open or when handling the lamp
1. If the projector is operating, turn it off and allow it to cool a minimum of 15 minutes.
2. Turn the breaker switch for the projector off.
3. Disconnect the projector from AC power.
4. Put on your protective clothing, face shield, and gloves.
5. Insert the key in the lamp door lock, turn the key, and then open the lamp door.
Solaria One User Manual
020-100841-02 Rev. 1 (11-2012)
This procedure should only be performed by a Christie accredited technician.
1-9