Stack Projectors - Christie Solaria One User Manual
Hide thumbs
Also See for Solaria One:
- Service manual (88 pages) ,
- Instruction sheet (20 pages) ,
- Retrofitting manual (15 pages)
Table of Contents
Advertisement
1.5
Stack Projectors
To stack Solaria One projectors, use the stacking kit provided with the projector. The Solaria One stacking kit
includes these parts:
NOTE: When stacking projectors, the optical axis of the projectors must be parallel to one another. The
maximum tilt for stacked projectors is 13 degrees. When you install the stacked projectors in a rack stand or on
a pedestal, the rack stand or the pedestal must remain horizontal. If you require tilt to align your images, you
must tilt the projectors and not the rack stand or pedestal.
1. On the bottom projector, remove the four corner screws securing the top lid.
2. Position a single stacking cup (011-104349-XX) over one of the empty screw holes so the higher side of
the cup faces outward and aligns with the projector skin.
3. Insert an M6 screw (012-101132-XX) through the stacking cup mounting hole and into the projector.
4. With a torque wrench, tighten the M6 screw to 15 in-lb.
5. Repeat steps 3 to 5 to install the three remaining stacking cups.
Solaria One User Manual
020-100841-02 Rev. 1 (11-2012)
Locking Bracket x 4
Stacking Cup x 4
M6 Screw x 4
1-5
Advertisement
Table of Contents
