Warn When Lamp Reaches (Hours); Lamp 1 S/N And Lamp 2 S/N; Change Lamp - Submenu; Lamp 1 History And Lamp 2 History - Christie M Series User Manual

3.8.8 Warn When Lamp Reaches (Hours)

This control causes the projector to present a warning message when the lamp has a recorded ON time that
exceeds the specified number of hours. The warning will be displayed via the status page for each lamp, where
applicable.
A value of 0 will turn this feature OFF.
NOTE: This setting is user-defined only. It has no bearing on lamp warranty and is not tied to actual lamp life
in any way.

3.8.9 Lamp 1 s/n and Lamp 2 s/n

This option allows the serial number for the current lamp to be changed. This will apply the serial number to
the current lamp statistics file. It will not archive the current statistics as done by the Change Lamp function.

3.8.10Change Lamp - Submenu

Initiates the lamp change process for the selected lamp and allows the serial number of the new lamp to be
entered. Lamp serial numbers are used for keeping statistics on each lamp used in each lamp position. Entering
of serial numbers is optional, but is recommended.
When using this function, the statistics from the previous lamp are archived, and starts statistics tracking for
the new lamp. If this function is not used, statistics are accumulated (combined) for both the new and old
lamps.

3.8.11Lamp 1 History and Lamp 2 History

Displays the serial number and the number of hours logged for each lamp (currently and previously) installed
in the projector. The top-most entry is always the most recent/current lamp.
3.9

Input Switching and PIP Menu

Use the Input Switching and PIP menu to
enable and define how you want to use PIP.
NOTE: To control the primary image, access
all picture controls through the Main menu. To
control the secondary (PIP) image, access
picture controls through the Input Switching
and Picture-in-Picture menu.

3.9.1 Main Input

From the list of active inputs, select one to be used as the primary or main image.

3.9.2 PIP Input

From the list of active inputs, select one to be used as the secondary or PIP.
M Series User Manual
020-100009-08 Rev. 1 (05-2013)
Section 3: Operation
3-53