Connect The Projector To A Computer; Connect The Projector To Network-Attached Storage; Connect The Projector To Direct-Attached Storage - Christie Solaria One User Manual

1.10.2 Connect the Projector to a Computer

Connect one end of an Ethernet or a RS232 cable to the Ethernet or the RS232 PIBS1 ports on the projector
communications panel and the other end to your computer. To communicate with the projector, the projector
must be added to the same network as the computer. See

1.10.3 Connect the Projector to Network-attached Storage

Your network-attached storage (NAS) device must be configured to use the Network File System (NFS)
protocol. Your direct attached storage (DAS) device must be connected to the projector and turned on before
the projector is turned on. Christie recommends that you select a static IP address, see
Port IP Addresses on page
1. Follow the instructions provided by the manufacturer of your NAS to ensure it is set up and operating
correctly.
2. Connect one end of an Ethernet cable to the NAS-1 or NAS-2 ports on the projector communications panel
and the other end to your NAS device or network.
3. Turn the NAS device on.
4. Connect the projector to AC power. See
5. Turn the projector on. See
6. Tap Menu > Christie IMB > System.
7. Tap Storage.
8. Tap Add NAS.
9. Tap Primary if this is your primary NAS device.
10. Tap Yes.
11. Complete the information fields for the NAS device.
12. Tap Refresh Share Names.
13. Select a share in the Share list.
14. Tap OK.
15. Tap Save.
16. Tap OK.

1.10.4 Connect the Projector to Direct-attached Storage

The direct attached storage (DAS) device must be connected to the projector and turned on before the projector
is turned on.
1. Verify the direct attached storage (DAS) device is connected to one of the external serial ATA (eSATA)
ports on the projector communications panel.
2. Turn the DAS device on.
3. Connect the projector to AC power. See
4. Turn the projector on. See
5. Tap Menu > Christie IMB > System.
6. Tap Storage.
1-14
13-18.
Connect Power on page
Turn the Projector On on page 1-16.
Connect Power on page
Turn the Projector On on page 1-16.
Add the Projector to a Network on page 1-17.
1-15.
1-15.
Configure NAS Ethernet
Solaria One User Manual
020-100841-02 Rev. 1 (11-2012)