Add The Lamp Information To The Lamp History; Turn The Lamp On; Align The Lamp With Lamploc - Christie CP2215 Quick Start Manual

Field
Management IP
Download MIB to USB
Apply
Serial Access
Ethernet Access

Add the Lamp Information to the Lamp History

1. If the lamp is on, tap the lamp off (
2. Tap Menu > Advanced Setup > Lamp Change Wizard.
3. Tap Next.
4. Complete these fields:
Field
Type
Serial Number
Reason for Change
Lamp Expiry (Hours)
Hours Used
5. Tap Save.
6. Tap Next.

Turn the Lamp On

On the projector touch panel controller (TPC) main screen, tap the lamp on (

Align the Lamp with LampLOC

To ensure optimal lamp performance and peak brightness at the screen for the life of the lamp, use
LampLOC to adjust the lamp position when you install a new lamp in the projector. After making the
adjustment, the lamp is well-centered and at the correct distance from the illumination system.
1. Turn the lamp on and open the douser.
CP2215 Quick Start Guide
020-101295-01 Rev. 1 (11-2013)
The IP address where SNMP information and notifications are sent.
Sends the SNMP Management Information Base (MIB) file to a USB flash
drive.
Applies SNMP settings.
Grants access to serial connections.
Grants access to Ethernet connections.
) icon to turn it off.
The lamp type.
The lamp serial number.
The reason the lamp was changed.
The number of hours the lamp can operate before replacement.
This field is auto-populated.
The number of hours the lamp has operated before installation.
Installation and Setup
Description
Description
) icon.
17