1: Installation And Setup; Safety Precautions; Ac/Power Precautions - Christie Solaria One User Manual

1 Installation and Setup
This manual is intended for professionally trained operators of Christie high-brightness projection systems.
These operators are qualified to replace the lamp and air filter, but should not attempt to install or service the
projector.
Only accredited Christie technicians who are knowledgeable about the hazards associated with high-voltage,
ultraviolet exposure, and the high temperatures generated by the projector lamp are authorized to assemble,
install, and service the projector. In addition, only Christie accredited personnel are authorized to perform
security procedures such as marriage.
This section provides information and procedures for positioning and installing the projector.
1.1

Safety Precautions

When installing the projector, observe these important safety rules to avoid personal injury or damage to the
projector:
WARNING
brightness can cause permanent eye damage. For protection from ultraviolet radiation, keep
all projector housings intact during operation. Protective safety clothing and safety goggles
are recommended when servicing.
WARNING
the concentrated light beam of the lamp.
tripped over.
This projector must be operated in an environment that meets the operating range specification, as listed in
Appendix A: Projector Specifications on page
1.1.1

AC/Power Precautions

WARNING
• Use only the AC power cord that is provided with the projector. DO NOT attempt operation
if the AC supply is not within the specified voltage and power range.
• As a safety feature the projector is equipped with a three-wire plug with a third (grounding)
pin. If you are unable to insert the plug into the outlet, contact an electrician to have the
outlet replaced. DO NOT defeat the safety purpose of the grounding-type plug.
• DO NOT attempt operation if the AC supply is not within the rated voltage range, as speci-
fied on the license label.
• Disconnect projector from AC before opening any enclosure.
• DO NOT allow anything to rest on the power cord. Locate the projector where the cord can-
not be damaged by persons walking on it or objects rolling over it. Never operate the pro-
jector if the power cable appears damaged in any way.
• DO NOT overload power outlets and extension cords as this can result in fire or shock haz-
ards.
• Only qualified service technicians are permitted to open projector enclosures and only if the
projector is disconnected from AC power.
Solaria One User Manual
020-100841-02 Rev. 1 (11-2012)
Never look directly into the projector lens or at the lamp. The extremely high
FIRE HAZARD! Keep hands, clothes, and all combustible material away from
Position all cables where they cannot contact hot surfaces or be pulled or
A-1.
1-1