Adding The Lamp Information To The Lamp History - Christie CP2208 User Manual

3. Complete these fields:
Field
Device Name
IP Address
Subnet Mask
Gateway
Apply
Serial Speed (Baud)
Enable SNMP
SNMP V2 / SNMP V3
Management IP
Download MIB to USB
Apply
Serial Access
Ethernet Access

Adding the lamp information to the lamp history

1. If the lamp is on, select Lamp Off to turn it off.
2. Select Menu > Advanced Setup > Lamp Change Wizard.
3. Select Next.
4. Complete these fields:
Field
Type
Serial Number
Reason for Change
Lamp Expiry (Hours)
Hours Used
5. Select Save.
6. Select Next.
CP2208 User Guide
020-101916-03 Rev. 1 (12-20120)
Copyright © 2020 Christie Digital Systems USA, Inc. All rights reserved.
Description
The name of the projector.
The IP address of the projector.
The subnet mask to which the address belongs.
The IP address for the network gateway.
Applies Ethernet settings.
The baud rate of the serial port. The default is 115200.
Enables SNMP.
The SNMP protocol type. Contact Christie for the SNMP V3 user ID and
password.
The IP address where SNMP information and notifications are sent.
Sends the SNMP Management Information Base (MIB) file to a USB flash
drive.
Applies SNMP settings.
Grants access to serial connections.
Grants access to Ethernet connections.
Description
The lamp type.
The lamp serial number.
The reason the lamp was changed.
The number of hours the lamp can operate before replacement. This field
is auto-populated.
The number of hours the lamp has operated before installation.
Installing and setting up
23