Adjust Tilt And Level The Projector; Install The Touch Panel Controller - Christie Solaria One User Manual

1.6

Adjust Tilt and Level the Projector

To ensure optimum performance of the projector, install the projector so it is
centered and parallel with the screen. To compensate for tilt or offset, you
can adjust the projector feet and the lens mount position.
To adjust the height of the projector, loosen the lock nut on the adjustable
feet on the bottom of the projector and then extend or retract the feet. When
the adjustment is correct, tighten the lock nut.
Use the lens mount to align the images of stacked projectors and not
projector tilt. If tilt is required to fit the image to the screen, tilt only the
lower projector.
NOTE: The front-to-back tilt of the projector must not exceed 15°.
1.7

Install the Touch Panel Controller

1. Loosen the mounting arm so that the end fits over the ball joint located on the rear panel of the projector.
2. Tighten the mounting arm until it fits tightly on the joint.
3. Connect the cable from the TPC to the connector located on the projector rear panel.
4. Tilt the TPC to adjust the viewing angle.
Solaria One User Manual
020-100841-02 Rev. 1 (11-2012)
1-7