Display Requirements; Sync Terminal Pin Map - Christie Solaria One User Manual

14 View 3D Content
This section provides information and procedures for setting up and managing 3D presentations.

14.1 Display Requirements

To display 3D images with the Solaria One projector, you require these items:
• A 3D hardware system:
• Pi-Cell polarizer for display on a screen that has a silver polarization-preserving surface for use with pas-
sive glasses (RealD).
• Rotating polarizing wheel (external) with passive circular polarizing glasses (MasterImage). Requires a
silver screen.
• IR emitter for controlling the left eye/right eye gating (switching) of active glasses (Xpand).
• Dual projector 3D - passive glasses (circular or linear). Requires a silver screen.
• A 3D connection cable.
• Power supply for your synchronization output device. The 3D sync port can power output devices.
14.2 3D Sync Terminal PIN Map
The 3D Sync terminal is a 15-pin D-sub connector (female) located on the projector communications panel.
This table lists the control functions available through the 3D connector.
PIN SIGNAL NAME
1 +12V
2 GND
3 GND
4 RS232_RX
5 RS232_TX
6 CONN_3D_MODE+
7 CONN_SYNC+
8 3D_INPUT_REFRERENCE+
9 +12V
10 3D_INPUT_REFRERENCE-
11 3D_DISPLAY_REFERENCE+
12 3D_DISPLAY_REFERENCE-
13 CONN_3D_MODE-
Solaria One User Manual
020-100841-02 Rev. 1 (11-2012)
DIRECTION DESCRIPTION
Out Power to 3D device. Maximum 1A (total between both
+12V pins).
/ Ground
/ Ground
In Data to projector from 3D device. 1200 Baud, 8 bits, no
parity. Currently unsupported.
Out Data to projector from 3D device. 1200 Baud, 8 bits, no
parity. Currently unsupported.
Out SYNC from projector. To projector GPO collector.
Compatible with current projector GPIO requirements
and restrictions. (24VDC max, 50mA max)
3D ON = Hi logic level = O/P transistor ON
3D OFF = Low logic level = O/P transistor OFF
Out SYNC from projector. To projector GPO collector.
Compatible with current projector GPIO requirements
and restrictions. (24VDC max, 50mA max)
In 3D L/R Input Reference (P)
(Voltage Limit: 2 VDC to 12VDC)
Out Power to 3D system. Maximum 1A (Total between both
+12V pins)
In 3D L/R Input Reference (N)
(Voltage limit: 1.4VDC to 12VDC)
In 3D L/R Input Reference (P)
(Voltage limit: 1.4VDC to 12VDC)
In 3D L/R Input Reference (P)
(Voltage limit: 1.4VDC to 12VDC)
Out 3D mode state from projector. From projector GPO
emitter. Compatible with current projector GPIO
requirements and restrictions. (24VDC max, 50mA
max)
14-1