Edit The Default 3D Lamp File; Define A Measured Color Gamut Data File; Edit The 3D Flat 1998 X 1080 Channel - Christie Solaria One User Manual

Field
Output Delay
Phase Delay
4. Tap Save.

14.6 Edit the Default 3D Lamp File

For 3D images to display correctly, you must edit the default 3D lamp file to match the specifications of your
3D hardware.
1. Tap Menu > Advanced Setup > Lamp Power / LiteLOC
2. Select Default 3D in the Current Lamp File list.
3. Set the brightness percentage for the lamp in the Power % field
4. Tap Save.

14.7 Define a Measured Color Gamut Data File

For 3D images to display correctly, you must define an MCGD file to match the specifications of your 3D
hardware.
1. Turn the lamp on and allow it to operate for 20 minutes.
2. Tap Menu > Advanced Setup > MCGD File Setup.
3. Hold a pair of 3D glasses in front of the light meter to determine the new x and y color coordinates for Red,
Green, Blue, and White. Use the same light path that you use to display a show.
4. Enter the x and y values in the Red, Green, Blue and White fields.
5. Tap Save As.
6. Enter 3D Onsite in the File Name field.
7. Tap Save.

14.8 Edit the 3D Flat 1998 x 1080 Channel

1. Tap Menu > Channel Setup.
2. Select 3D Flat 1998x1080 in the Channel Name list.
3. Tap Config 1 in the left pane and edit these settings:
a. Select 292-Dual in the Input list.
b. Select YCrCb 4:2:2 10 bits x2 in the Data Format list.
c. Select 1998x1080 1.85 Flat in the Source File list.
d. Select Flat in the Screen File list.
14-4
Description
The non-image time in Microseconds (μ). Offset 3D stereo sync output in
relation to dark time interval. Acceptable values are between -32768 and 32767
are accepted where a positive offset = delay and negative offset = start early. Tap
Launch Dialog to enter the output delay value.
The degree of reference between the left and right sync output. Values between -
180 and 180 are accepted. Tap Launch Dialog to enter the phase delay value.
™
Setup.
.
Solaria One User Manual
020-100841-02 Rev. 1 (11-2012)