Clean The Lens; Replace The Lamp; Remove The Existing Lamp - Christie Solaria One User Manual

15.3.1 Clean the Lens

A small amount of dust or dirt on the lens has minimal effect on image quality-to avoid the risk of scratching
the lens, clean the lens only if absolutely required.
Remove Dust
1. Brush most of the dust off with a camelhair brush or use a dust-free blower.
2. Fold a microfiber cloth and wipe the remaining dust particles off the lens with the smooth portion of the
cloth that has no folds or creases. Do not apply pressure with your fingers. Instead, use the tension in the
folded cloth to remove the dust.
3. If significant dust remains on the lens surface, dampen a clean microfiber cloth with lens cleaning solution
and wipe gently until clean.
Remove Fingerprints, Smudges, or Oil
1. Brush most of the dust off with a camelhair brush or use a dust-free blower.
2. Wrap a lens tissue around a swab and soak it in lens cleaning solution. The tissue should be damp but not
dripping.
3. Gently wipe the surface using a figure eight motion. Repeat until the blemish is removed.

15.4 Replace the Lamp

DANGER
EXPLOSION HAZARD. Wear authorized protective clothing whenever the lamp door is open and when
handling the lamp. Never twist or bend the quartz lamp body. Use the correct wattage lamp supplied by
Christie. 3) Ensure those within the vicinity of the projector are also wearing protective safety clothing.
4) Never attempt to remove the lamp when it is hot. The lamp is under pressure when hot and may
explode, causing personal injury, death, or property damage. Allow the lamp to cool completely before
replacing it.
WARNING

15.4.1 Remove the Existing Lamp

1. Tap and hold the red power button
2. Allow the lamp to cool for a minimum of 15 minutes.
3. Unplug the projector.
4. Put on your protective clothing and face shield.
5. Insert the key in the lock on the lamp door, turn the key, and then open the lamp door. Do not place heavy
objects on the open lamp door.
15-2
1)Lamp replacement must be performed by a qualified service technician. 2)
Improper installation of the lamp can damage the projector.
on the TPC Main panel to turn the lamp and projector off.
Solaria One User Manual
020-100841-02 Rev. 1 (11-2012)