Replace The Lens - Christie Solaria One User Manual

5. Loosen the 2 captive screws on the cap plate and then remove it.
6. Slide the air filter out and then discard it.
7. Insert the new air filter with the airflow indicator facing toward the projector.
8. Install the cap plate and tighten the 2 captive screws.
9. Install the service panel and then tighten the 2 screws.
10. Install the top lid.

15.7 Replace the Lens

The lens seals the projection head, preventing contaminants from entering the main electronics area. Do not
operate the projector without a lens installed. Install a lens plug when you install or transport the projector.
1. Tap and hold the red power button
2. Allow the lamp to cool for a minimum of 15 minutes.
3. Disconnect the projector from AC power or turn the circuit breaker off.
4. Remove the lens surround.
5. Install the lens cap and turn the lens clamp to the open position with a hex key.
6. If necessary, remove the 2 cap screws securing the lens to the lens mount using a hex key.
7. Pull the lens out of the lens mount and then install a small lens cap on the rear of the lens.
8. Remove the small rear cap from the new lens. Keep the front cap on.
9. Align the tabs on the lens plate with the lens mount. Insert the lens until it connects with the magnets on
the mount. When the lens contacts the magnetic plates it is seated correctly.
10. Secure the lens clamp by rotating it clockwise with a hex key.
11. Tighten the lens mount cap screws for added stability.
12. Replace the lens surround.
13. Remove the lens cap from the front of the lens.
Solaria One User Manual
020-100841-02 Rev. 1 (11-2012)
on the TPC Main panel to turn the lamp and projector off.
15-7