Align Dual Projector Images - Christie Solaria One User Manual

1.20

Align Dual Projector Images

1. Stack the projectors. See
2. On the bottom projector, adjust the image to fit the screen. See
1-19.
3. On both projectors, turn the lamp on and open the douser. See
4. On the top projector, display a RGB-12bit-Full Screen White test pattern and center the image:
a. Tap the Test Pattern icon (
b. Tap All Test Patterns.
c. Tap RGB-12bit-Full Screen White.
d. Hold a sheet of translucent paper in front of the lens of the bottom projector.
e. Turn the vertical and horizontal knobs on the front of the projector clockwise and counterclockwise to
center the light created by the projector on the screen.
5. On the top projector, display the DC2K Framing Green test pattern. See
page 12-1.
6. On the bottom projector, display the DC2K Framing Red test pattern. See
on page 12-1.
7. Align the top projector image horizontally to the bottom projector:
a. On the top projector, remove the locking brackets from the projector feet.
b. Move the front or the rear of the top projector to the right or left so the projected image is aligned hor-
izontally with the image of the bottom projector.
8. Align the top and bottom projector images vertically:
a. Raise or lower the rear feet of the top projector so the projected images of both projectors are vertically
aligned. The lines appear yellow when the images are aligned correctly
b. Reinstall the locking brackets removed in step 7.
Solaria One User Manual
020-100841-02 Rev. 1 (11-2012)
Stack Projectors on page 1-5.
in the task bar.
)
Adjust the Image to Fit Your Screen on page
Turn the Lamp On on page 1-18.
Turn a Test Pattern On or Off on
Turn a Test Pattern On or Off
.
1-21