Modify Projector Communication Settings; Add A Network Device; Access A Network Device - Christie Solaria One User Manual

9.3

Modify Projector Communication Settings

You need Administrator or Service permissions to complete this procedure.
1. Tap Menu > Administrator Setup > Communications Configuration.
2. Complete these fields:
Field
Device Name
IP Address
Subnet Mask
Gateway
Apply
Serial Speed (Baud)
Enable SNMP
SNMP V2 / SNMP V3
Management IP
Download MIB to USB
Apply
Serial Access
Ethernet Access
9.4

Add a Network Device

You need Administrator or Service permissions to complete this procedure.
1. Tap Menu > Administrator Setup > Network Devices Setup.
2. Tap the check box. If the check box is not selected, the device does not appear in the Network Devices
menu.
3. Tap the Launch Dialog
4. Tap Enter.
5. Tap the Launch Dialog
6. Tap Enter.
9.5

Access a Network Device

Tap Menu > Network Devices > Christie ACT
To interact with the device tap
9-2
Description
The name of the projector.
The IP address of the projector.
The subnet mask to which the address belongs.
The IP address for the network gateway.
Applies Ethernet settings.
The baud rate of the serial port. The default is 115200.
Enables SNMP.
The SNMP protocol type. Contact Christie for the SNMP V3 user ID and password.
The IP address where SNMP information and notifications are sent.
Sends the SNMP Management Information Base (MIB) file to a USB flash drive.
Applies SNMP settings.
Grants access to serial connections.
Grants access to Ethernet connections.
icon in the Device Name field and enter a name for the network device.
icon in the URL field and enter the URL for the network device.
in the top right corner of the window.
Solaria One User Manual
020-100841-02 Rev. 1 (11-2012)