Connect Devices To The Projector; Projector Connections - Christie Solaria One User Manual

11. Close the fire wall door and tighten the 2 thumbscrews.
12. Close and lock the rear access door. NOTE: Ensure the hex key is placed back into its holder before
closing the rear access door.
1.10

Connect Devices to the Projector

To display content, you must connect a device that is capable of storing or playing content to the projector.

1.10.1 Projector Connections

2
3
1
NAS
Main Power
TPC Disconnect
PIBS1 Health
11
ICP Health
IMB Health
Ethernet
17
Feature
1
1-12
SOFTST OSST FMTST
IMB Power
2
FPGA Load
SM Run
FIPS
OS Load
SMS Run
Alarm
USB/eSATA
eSATA A eSATA B
DAS
4
Marriage Emergency
System
Start Reset
13 14
12
LEDs indicating the status of projector components:
SOFTST - (Software State) Indicates the state of the software application running on
the ICP. During normal operation, this LED blinks. During start up, the LED changes
from off to blinking.
OSST - (Operating System State) Indicates the state of the ICP operating system.
During normal operation, the LED is green. During start up, the LED changes from
off to green.
FMTST - (FMT FPGA State) Indicates the state of the FMT FPGA. During normal
operation, the LED is green. When the power is turned on, the LED turns green
immediately.
ICPST - (ICP FPGA State) Indicates the configured state of the ICP FPGA. During
normal operation, the LED is green. When the power is turned on, the LED turns
green immediately.
1
GEN Lock Sync Out
IMB
Reset
Ingest
7 8
5 6
3D Sync
15
RS 232 PIBS1
16
HDMI A / LEFT
18
Description
LTC Out
AES3
9 10
HDMI B / RIGHT
17
Solaria One User Manual
020-100841-02 Rev. 1 (11-2012)