Removing And Installing Steering Lock Housing - Volkswagen up! 2012 Workshop Manual

up! 2012 ➤
Electrical system - Edition 03.2017
– Fold aside ignition key as far as possible.
– Insert locking pin - T40011- or suitable welding wire as far as
stop in hole -2-, and release lock cylinder -1-.
– Pull lock cylinder -1- together with immobiliser reader coil - D2-
out of steering lock housing.
WARNING
Risk of seized steering lock.
♦ The steering lock must not be actuated without lock cylin‐
der.
Note
A seized steering lock must be renewed.
Installing
Install in the reverse order of removal, observing the following:
Note
A new lock cylinder can be ordered from the responsible distri‐
bution centre or the importer. When ordering, the vehicle-specific
locking number according to the VIN must be provided.
– Insert ignition key into lock cylinder and turn it to position "Ig‐
nition On".
– Insert locking pin - T40011- or suitable welding wire as far as
stop into hole -2- again.
– Insert lock cylinder -1- together with immobiliser reader coil -
D2- in steering lock housing -3-.
– Pull locking pin - T40011- or suitable welding wire out of hole
-2-.
– Press in lock cylinder tightly until locking mechanism can be
heard to engage.
– Connect connector to immobiliser reader coil - D2- .
7.2.9 Removing and installing steering lock
housing
Removing
– Remove steering column combination switch - E595-
⇒ page 106 .
112
Rep. gr.94 - Lights, bulbs, switches - exterior