CHAPTER 4 IMAGE FORMATION SYSTEM
K. Developing Assembly
Caution:
The machine's developing assembly is not equipped with a developing cylinder
protection cover, requiring you to take care whenever you have removed the
developing assembly.
If the developing assembly is not set inside the copier, be sure not to install the
developing assembly locking assembly. Otherwise, the toner collecting in the path
through which toner is fed from the hopper to the developing assembly can start to
pour out because of the vibrations caused by inspection/repair work.
1. Removing the Developing Assembly from the Copier
1) Open the multifeeder door; then, remove the mounting screw, and remove the door
stopper tape.
2) Remove the mounting screw
assembly
in the direction of the arrow to remove.
3) Disconnect the connector
copier.
4-60
COPYRIGHT © 1997 CANON INC.
Download service manual and resetter printer at http://printer1.blogspot.com
, and push the developing assembly locking
Figure 4-335
, and slide out the developing assembly
Figure 4-336
CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
from the