Lamp Unit .................................4-43
Assembly .......................................4-44
Drum.........................................4-47
Assembly .......................................4-49
Assembly ..................................4-49
Assembly ..................................4-51
1. Outline ......................................4-53
CHAPTER 5 PICK-UP/FEEDING SYSTEM
I.
A. Outline ...........................................5-1
II.
1. Outline ......................................5-5
1. Outline ......................................5-8
Paper ........................................5-8
Rail ...........................................5-10
Value.........................................5-12
COPYRIGHT © 1997 CANON INC.
Download service manual and resetter printer at http://printer1.blogspot.com
III.
IV.
CANON NP6350/NP6251 REV.0 JULY 1997 PRINTED IN JAPAN (IMPRIMÉ AU JAPON)
2. Removing the Wire Cleaner of
the Primary Charging
Assembly ..................................4-53
3. Stringing the Charging Wires ...4-53
4. Stringing the Grid Wire of the
Primary Charging Assembly.....4-56
5. Adjusting the Height of the
Charging Wire ..........................4-58
6. Cleaning the Primary Charging
Assembly Anti-Stray Sheet ......4-59
K. Developing Assembly ....................4-60
1. Removing the Developing
Assembly from the Copier........4-60
2. Removing the Blade Unit .........4-61
3. Installing the Blade ...................4-61
4. Removing the Developing
Cylinder and the Magnetic
Seal ..........................................4-62
5. Cleaning the Developing
Assembly Anti-Stray Sheet ......4-65
L. Hopper Assembly ..........................4-66
1. Removing the Hopper
Assembly from the Copier........4-66
M. Drum Cleaner ................................4-67
1. Construction .............................4-67
2. Removing the Cleaning Blade..4-67
3. Installing the Cleaning Blade....4-68
4. Installing the Side Seal.............4-69
5. Cleaning the Cleaning Side
Scraper .....................................4-70
N. Separation Claw/Separation
Claw Drive Assembly ....................4-71
1. Removing from the Drum Unit .4-71
O. Waste Toner Feeding Assembly....4-72
A. Outline ...........................................5-13
Absence of Paper in the Deck ..5-19
vii