Canon NP6251 Service Manual page 14

5. Positioning the Roll ..................8-34
C. Drive System .................................8-35
1. Removing the Deck Pick-Up
Clutch (CL102) .........................8-35
2. Removing the Deck Vertical
Path Clutch (CL101).................8-35
3. Removing the Deck Main
Motor (M101)............................8-36
4. Removing the Deck Lifter
Motor (M102)............................8-37
5. Removing the Lifter Cable
(deck front) ...............................8-38
6. Removing the Lifter Cable
(deck rear) ................................8-40
7. Routing the Lifter Cable ...........8-43
D. Feeding System ............................8-44
1. Removing the Deck Pick-Up
Unit ...........................................8-44
2. Removing the Deck Pick-Up
Roller ........................................8-45
I. SELECTING THE SITE ......................9-1
II. UNPACKING AND INSTALLING ........9-4
A. Unpacking......................................9-5
B. Installing the Scanner....................9-7
C. Installing the Fixing Assembly .......9-8
D. Installing the AP Kit and the
Charging Assemblies ....................9-10
E. Installing the Copy Tray.................9-16
1. Replacing the Delivery Gear ....9-16
2. Replacing the Delivery Roller
Leaf Spring ...............................9-17
F. Checking the Developing
Assembly .......................................9-18
G. Installing the Pick-Up Assembly ....9-20
H. Supplying Toner.............................9-22
CHAPTER 10 MAINTENANCE AND SERVICING
I. PERIODICALLY REPLACED
PARTS ..............................................10-1
II. CONSUMABLES AND DURABLES.10-2
A. Copier..........................................10-2
B. Paper Deck-A1 ............................10-3
xii
COPYRIGHT © 1997 CANON INC.
Download service manual and resetter printer at http://printer1.blogspot.com
CHAPTER 9 INSTALLATION
CANON NP6350/NP6251 REV.0 JULY 1997 PRINTED IN JAPAN (IMPRIMÉ AU JAPON)
3. Orientation of the Deck
Pick-Up Roller ..........................8-45
4. Removing the Deck Feeding
Roller ........................................8-46
5. Orientation of the Deck
Feeding Roller ..........................8-46
6. Removing the Deck Separation
Roller ........................................8-47
7. Adjusting the Deck Separation
Roller Pressure.........................8-48
8. Positioning the Deck Pick-Up
Roller Releasing Solenoid
(SL101).....................................8-48
E. Electrical System ...........................8-49
1. Removing the Side Deck
Driver PCB ...............................8-49
2. Removing the OPEN Switch
PCB ..........................................8-49
I. Connecting the PDF Connector ....9-26
J. Image/Function Checks and
User Mode .....................................9-27
III. RELOCATING THE MACHINE...........9-31
IV. INSTALLING THE CONTROL
CARD V ..............................................9-32
V. INSTALLING THE COPY DATA
CONTROLLER-A1 .............................9-40
A. Setting the Board...........................9-40
B. Installing to the Copier ..................9-44
C. Checking the Operation.................9-46
VI. INSTALLING THE REMOTE
DIAGNOSTIC DEVICE II....................9-56
A. Installation to the Copier ...............9-56
III. SCHEDULED SERVICING TABLE ..10-4
IV. SCHEDULED SERVICING CHART .10-6
A. Copier ..........................................10-6
B. Paper Deck-A1 ............................10-8