Removing The Holding Tray X Motor; Removing The Holding Tray Re-Circulating Motor - Canon NP6251 Service Manual

16. Removing the Holding Tray X Motor

1) Remove the side guide plate assembly.
2) Remove the mounting screw, and remove the motor cover.
3) Remove the two mounting screws
the motor .

17. Removing the Holding Tray Re-Circulating Motor

1) Remove the side guide plate assembly.
2) With the paper jogging guide plate fully open, mark the position of the paper jogging
guide plate assembly with a pencil or the like. (See Figure 5-900.)
3) Remove the three mounting screws
remove the rear guide plate assembly
COPYRIGHT © 1997 CANON INC.
Download service manual and resetter printer at http://printer1.blogspot.com
, and disconnect the connector; then, remove
Figure 5-894
, and disconnect the connector
.
Figure 5-895
CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 5 PICK-UP/FEEDING SYSTEM
; then,
5-113