Removing The Lifter Cable - Canon NP6251 Service Manual

CHAPTER 5 PICK-UP/FEEDING SYSTEM

2. Removing the Lifter Cable

1) Remove the paper deck.
2) Remove the two mounting screws
on the side; then, remove the deck front cover
3) Remove the two mounting screws
guide plates .
4) Mark the position of the latch assembly; then, remove the left and right mounting
screws (7 in total), and remove the latch assembly
5) Remove the gear cover
5-72
COPYRIGHT © 1997 CANON INC.
Download service manual and resetter printer at http://printer1.blogspot.com
above, and loosen the two mounting screws
inside the deck, and remove the front and rear
Figure 5-821
from the front right.
Figure 5-822a (left)
CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
.
.