CHAPTER 8 PAPER DECK-A1
6. Removing the Lifter Cable (deck rear)
1) Open the compartment; remove all copy paper, if any.
2) Remove the screw, and remove the rear edge guide plate inside the compartment.
3) Push the sensor lever
with a finger to lower the lifter until the holes (left/right) in the compartment side plate
and the holes in the lifter (left/right) match; then, insert two screwdrivers
time, try to keep the top face of the lifter along the line marked on the left side plate
of the compartment to facilitate the work.)
8-40
COPYRIGHT © 1997 CANON INC.
Download service manual and resetter printer at http://printer1.blogspot.com
of the paper supply position sensor inside the compartment
Line marked
Figure 8-409
CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
. (At this