Installing The Fixing Heater; Removing The Fixing Upper Roller - Canon NP6251 Service Manual

Hide thumbs Also See for NP6251:
Table of Contents

Advertisement

7. Installing the Fixing Heater

Install the heater by reversing the steps used to remove it with the following in mind:
a. Do not touch the surface of the heater.
b. Orient both heaters so that the sides with longer heater wires are toward the front.
c. Install the main heater (790 W) to the right and the sub heater (410 W) to the left
when viewing from the front.
d. While viewing from the rear of the copier, connect the faston on the right to the main
heater and the faston at the top to the sub heater.

8. Removing the Fixing Upper Roller

1) Slide out the fixing/feeding unit from the copier.
2) Remove the fixing/feeding assembly front cover.
3) Open the fixing/delivery assembly.
4) Remove the flywheel.
5) Remove the fixing upper cover, and remove the fixing cleaning belt; then, clean the
silicone oil pan, and remove the fixing upper unit.
6) Remove the main heater and the sub heater.
7) Remove the two mounting screws
in place, and release the web.
8) Remove the two mounting screws
COPYRIGHT © 1997 CANON INC.
Download service manual and resetter printer at http://printer1.blogspot.com
used to hold the fixing cleaning belt assembly
Figure 6-216
, and remove the heater holder
Figure 6-217
CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 6 FIXING SYSTEM
at the rear.
6-27

Advertisement

Table of Contents
loading

This manual is also suitable for:

Np6350

Table of Contents