Canon NP6251 Service Manual page 549

CHAPTER 11 TROUBLESHOOTING
6) Hook the loop on the stud A shown in Figure 11-220.
7) After routing the wire for 31 runs, lead it through section B, give it a 1/2 turn, lead it
between washer and motor unit, wind it once around the mounting screw clockwise,
and fix it in place with the mounting screw.
8) Cut the excess charging wire with a nipper.
9) Tighten the mounting screw loosened in step 8).
Take care to avoid deformation (slack) of the charging assembly. Try to tighten the
mounting screw (front) on the shielding plate (left, right) earlier.
11-18
COPYRIGHT © 1997 CANON INC.
Download service manual and resetter printer at http://printer1.blogspot.com
Stud A
Figure 11-220
CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
Screw
B