Sliding Out The Hopper Assembly; Removing The Process Unit - Canon NP6251 Service Manual

CHAPTER 7 EXTERNALS/AUXILIARY MECHANISMS

5. Sliding Out the Hopper Assembly

1) Open the front door, and open the hopper cover
screws ; then, remove the three mounting screws
Disconnect the connector, and slide out the hopper
Caution:
Check to make sure that the connector is connected before installing the hopper
assembly.

6. Removing the Process Unit

1) Open the front door.
2) Remove the developing assembly. (See p. 4-60.)
3) Remove the hopper assembly. (See p. 4-66.)
4) Slide out the fixing/feeding assembly, and place the drum protection sheet on the
registration roller assembly.
5) Disconnect the four connectors
7-18
COPYRIGHT © 1997 CANON INC.
Download service manual and resetter printer at http://printer1.blogspot.com
. Remove the three mounting
Figure 7-409
, and remove the two mounting screws
Figure 7-410
CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
, and connector cover.
to the front and turn it.
.