7. Installing the Process Unit
Install the process unit by reversing the steps used to remove it with the following in
mind:
1) When placing the processing unit, be sure to align it along the guide plates
front and the rear of the left rail.
On the right rail side, be sure to place the process unit on the L-shaped stay.
2) After inserting the process unit into the copier, match the cut-in of the drum shaft and
the cut-in of the drum using the drum rotating tool
, and fit the mounting screw
COPYRIGHT © 1997 CANON INC.
Download service manual and resetter printer at http://printer1.blogspot.com
Figure 7-414 (rail side)
into the center hole of the drum to fix it in place.
Figure 7-415
CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 7 EXTERNALS/AUXILIARY MECHANISMS
; then, insert the drum fixing tool
at the
7-21