Table of Contents
Advertisement
Continued from the preceding page
(8) Operation for setting the object conditions
1. Press the ESC key, and all of the menus used for setting the edge detection condition will be
displayed.
1DETECT MODE
2
2DETECT DIRECTION HORI (
3
3DETECT AREA
4THRESHOLD
4
5PROC. PROJECTION NO YES
qUPPER MENU
2. Move the cursor to 1 DETECT MODE (detection mode) with the up and down keys, and
press the SET key. Move the cursor to CNTR (DRK) (center, dark) with the left and right keys,
and press the SET key.
3. Move the cursor to 2 DETECT DIRECTION (detection direction) with the up and down keys,
and press the SET key. Move the cursor to HORI (horizontal) (_) with the left and right keys,
and press the SET key.
4. Move the cursor to 3 DETECT AREA (detection window) with the up and down keys, and
press the SET key. Move the cursor to MOVE with the left and right keys, and press the SET
key.
- Move the detection line to the left of the lead to be measured with the up, down, left and right
keys.
Detection line
- When the position of the line is correct, press the SET key.
5. Move the cursor to LO.R (lower right) with the left and right keys, and press the SET key.
- Extend the detection line to the right lead with the right key.
Detection line
- When the position is correct, press the SET key and ESC key.
6. Move the cursor to qUPPER MENU with the up and down keys, and press the SET key.
- The screen will return to the [MEASURING COND] (measurement conditions) menu.
7. Press the ESC key.
- The screen will return to the [TYPE00-MEAS1] (type: 00, measurement: 1) menu.
Continued on the following page
CNTR(BRT DRK)
) VERT (
MOVE UP.L(224,208) LO.R(287,271)
GRYS.050(0~255) EDGE.W 2(1~8)
FLAT. W04(1~16)
3-35
Operation Examples (Lead inspection)
)
3
Advertisement
Table of Contents
