Table of Contents
Advertisement
Continued from the previous page: GRAY&EDGE, GRAV.
[EVALUATION COND]
1OBJECT :
2REGST NO.
3X START PNT COORD 000.0~511.0
4Y START PNT COORD 000.0~479.0
5DEGREE OF MATCH
6MAKE A TEST RUN (SET KEY)
7UPPER MENU
Evaluation conditions
1OBJECT
2REGST NO.
(registration number)
3
4
5
6MAKE A TEST RUN
7UPPER MENU
1OBJECT: When AUX (auxiliary) is selected
1OBJECT :
2REGST NO.
3AUX. X COORD 000.0~511.0
4AUX. Y COORD 000.0~479.0
1OBJECT: When DIST (distance) is selected
1OBJECT :
2REGST NO.
3DISTANCE
1OBJECT: When ANGLE is selected
1OBJECT :
2REGST NO.
3ANGLE
- Check your selection by testing the upper and lower limits for the evaluation that you have set.
This can be done using item 6 MAKE A TEST RUN.
- For more information about evaluation conditions see section 9-2 [3] Evaluation conditions .
Return to the [TYPE00-MEAS1 to 3] and select item 8 NUMERIC CAL COND
(numeric calculation condition).
Continued on the following page
(TYPE00-MEAS.1-DST&ANGL MEAS)
ST-PNT AUX DIST
[TEST RESULT]
ANGLE
00(0~15) GRAY-SEARCH
X=285.0 OK NO
Y=250.0 OK NO
-10000~ 10000
+09800
Select the object for evaluation.
Set this at any number from 0 to 15.
Enter the ranges that will produce an OK decision.
The titles of items 3 to 5 will change, according to the settings in item
1. The example above shows the display when 1OBJECT: ST-PNT
(starting point) has been selected. See below for the displays when
other object settings are selected.
Pressing the SET key will test the evaluation condition, display the test
results.
This will return you to the [TYPE00-MEAS1 to 3] menu.
ST-PNT AUX DIST
ANGLE
00(0~15) CNTR-PNT
ST-PNT AUX DIST
ANGLE
00(0~15) DIST-BETW-2PT
000.0~702.0 PIXEL
ST-PNT AUX DIST
ANGLE
00(0~15) 3PT-ANGL
-180.0~ 180.0
9-67
Distance and angle measurement
Alternatively, EDGE DETECT (tip
of the edge) or GRAVITY (label
[OUT]
center of gravity) may also be
displayed here.
OK NO
Use the up and down keys to
select NO, Y0 to 7, or C000
to C127.
Setting details
PERIMRTER (center of a circle), C-GRAV
(center of gravity), LEG (lines on two points),
INTRSCT-PT (crosspint over two lines) or NO
(disabled) may also be displayed here.
DIST-BETW-X, DIST -BETW-Y, NO may also be
displayed here.
2PT-ANGL(HORI) (2 point horizontal),
2PT-ANGL(VERT) (2 point vertical) or NO (disabled)
may also be displayed here.
9
Advertisement
Table of Contents
