Table of Contents
Advertisement
Object identification (labeling) by binary conversion
[2] Setting details
An explanation of the 6 MEAS.PROG.COND (conditions for measurement programs) from the
[TYPE00-MEAS1 to 3] (object type measurement) menu.
On the MAIN OPS MENU, move the cursor to SET-SCRN, and press SET key.
- On the [SYSTEM SETUP] menu, move the cursor to 2 OBJECT TYPE COND (conditions of
object type) and press the SET key.
- Select item 0 MEASUREMENT 1, q MEASUREMENT 2 or w MEASUREMENT 3
Select item 6 MEAS.PROG.COND (conditions for measurement programs).
9
Select item 2 BINARY AREA COND (conditions for binary areas).
Continued on the following page
on the [OBJECT TYPE COND] menu .
[TYPE00-MEAS1]
1MEAS SELECTION NO
2COMPARE IMAGES NO YES(CAM1)
3SELECT CAMERA CAM1 CAM2
4COPY
5INITIALIZATION
6MEAS.PROG. COND (TO NEXT SUB-MENU)
7EVALUATION COND (TO NEXT SUB-MENU)
8NUMERIC CALC COND (TO NEXT SUB-MENU)
9OUTPUT CONDITIONS (TO NEXT SUB-MENU)
0UPPER MENU
- Select LABEL-BIN-OBJ (object identification by binary conversion) in
item 1
- Item 2 will be displayed unless NO is selected in item 8 SELECT CAMERA IMG
(camera selection) which is in the [OBJECT TYPE COND] (conditions of object type)
menu.
[MEASURING COND] (TYPE00-MEAS.1-LABEL-BIN-OBJ)
1REGST NO.
00(0~3) REG.NO YES
2BINARY AREA COND (TO NEXT SUB-MENU)
3FIND CENT/GRAVITY NO YES
4MAIN AXIS ANGLE NO YES
5FILLET DIAMETER NO YES
6PERIMETER LENGTH NO YES
7UPPER MENU
- If YES was specified in item 1 REGST NO. (registration number), then items 2 to 6 will be
displayed.
Mesurement conditions
1 REGST NO.
(registration number )
2 BINARY AREA COND
(condition for binary areas)
3 FIND CENT/GRAVITY
(center of gravity
measurement)
4 MAIN AXIS ANGLE
5 FILLET DIAMETER
(fillet width)
6 PERIMETER LENGTH
(circumference)
7 UPPER MENU
CHECK-DEG-OF-MATCH
DST&AGL MES. (GRAY&EDGE GRAV)
INSPECT-LEAD MEASR-BIN-AREA
CNT-BIN-OBJ LABEL-BIN-OBJ
POINT MEAS
EXEC TYPE00 MEAS1 NO
EXEC
Setting details
Set this to any number from 0 to 3 and select NO or
YES to store it.
The conditions for binary areas are set on the next
menu.
Select YES/NO for each of the measurements.
- See page 9Æ102.
This will return you to the [TYPE00-MEAS1 to 3] menu.
9-100
This is how the line
looks when the ob-
ject type is set to
00 and the selec-
ted measurement
is 1.
Advertisement
Table of Contents
