Table of Contents
Advertisement
Continued from the preceding page
(10) Returning to the MAIN OPS MENU
1. Press the ESC key.
- The screen will return to the [SYSTEM SETUP] menu.
- Move the cursor to 9 SAVE IN FLASH MEM (save data in flash memory) or 0
OPERATIONS with the up and down keys, and press the SET key.
- The following message will be displayed on the upper part of the screen.
DATA SAVE? (Do you want to save data ?) (YES=[MOVE]/NO=[ESC])
- Press the SET key.
- The data saving operation will start, and the progress will be displayed on the bottom
of the screen.
When the data has been saved in the IV-S20 flash memory, the display will change
from "SAVING" to "SAVING COMPLETE."
Note:
· If the ESC key is pressed, the settings you entered will not be saved in the IV-S20
flash memory. In this case, if the power to the IV-S20 main housing is turned OFF, or
if the type No. is changed, the settings will be deleted.
2. Press the ESC key.
- The screen will return to the MAIN OPS MENU.
- If the cursor was moved to 0 OPERATIONS in step 1 above, the screen will
automatically return to the MAIN OPS MENU.
Continued on the following page
SAVING
REFERENCE IMAGE
SYSTEM I/O
MEAS CONDITIONS
3-13
Operation Examples (Position measurement)
3
Advertisement
Table of Contents
