Table of Contents
Advertisement
Run Menu Conditions and Settings
· Simultaneous display on a divided screen
(When CAM1&2 has been specified in item 1
MONITOR OUTPUT.)
When item 2 CAMERA1&2, has been
set to CAM1=MD CAM2=MD
(2) Output monitor switching by parallel input
On the [MAIN OPS MENU], move the cursor to SET-SCRN item, and press the SET key.
Move the cursor to 3 I/O CONDITIONS (input/output conditions) on the [SYSTEM SETUP]
8
menu, and press the SET key.
C1MD
C2MD
[IN/OUT SETTINGS]
1MEAS TRIG INP I/F PARALLEL SERIAL CCD-TRG
3SERIAL OUTPUT
(INPUT-PARALLEL)
4CHG MEAS NO.X5,X6 NO YES
5PARALLEL INPUT X5 EXT-INP. REG-REF-IMG(MSR0)
6PARALLEL INPUT X6 EXT-INP. CHG-IMG-OUT-CAM CAM-MEAS
7OUTPUT STATUS
8SERIAL CONDITIONS(TO NEXT SUB-MENU)
9COMPUTER LINK
0GAIN-OFFSET
qUPPER MENU
· Item 2 is displayed when CCD-TRG. (CCD trigger) has been specified in item 1.
· Set PARALLEL INPUT X6 to CHG-IMG-OUT-CAM.
· Every time the signal X6 is turned ON from OFF, camera display will be switched.
Camera 1 on
the whole screen
Note: You can change the display part of the image from the CAM1 & 2 to the
UP, MD or LO by key input or by using a general-purpose serial interface command.
· An the example of the display on the MAIN OPS MENU is the same as that shown in
Item (1) above "Output monitor switching by key input."
When CAM1 has been set to UP
When CAM1 has been set to LO
When CAM2 has been set to UP
When CAM2 has been set to LO
NO PC-LINK SERIAL
BUSY READY
(TO NEXT SUB-MENU)
(TO NEXT SUB-MENU)
Cameras 1 and 2
Camera 2 on
on a divided screen
the whole screen
8-2
C1UP
C1LO
C2UP
C2LO
Advertisement
Table of Contents
