Sharp IV-S20 User Manual page 207

Distance and angle measurement
Continued form the previous page
Pressing the TRG/BRT key will run a measurement of distance and angle after manually measuring
the starting point.
Below is an example of the results display for a distance measurement.
[Display of measured results]
Final evaluation result
Measuring time
Measurement number, camera
number and measurement type
contents (gray scale or center
of gravity)
Distance number
Measurement of distance
(in pixels) and decision result
The X and Y coordinates of the
starting point numbers
· By moving the cursor to REG-CHNG (change registration) and pressing the up key, it is
possible to see the measurement results corresponding to other types of data which may be
scrolled through in this order: distance number (00 to 15), angle number (00 to 15), starting
point number (00 to 15), auxiliary point number (00 to 15) and then returning again to
9
distance number (which is the type of data currently on the display in the illustration above).
Pressing the down key in these situations will scroll backwards in the opposite order.
· Unregistered numbers will be skipped.
· When there are no recorded numbers (other than those currently on display), or if no
measurement has actually been carried out, then it will not be possible to switch back and
forth between data.
· The following are some examples of other displays.
Example of the display of angle results
Angle number [angle type]
Measurement of angle
and results of decision
Starting point number
(X and Y coordinates)
(TYPE00)
OK
MEAS. XXXXXXms
MEAS1 CAM1 DST&AGL GRAY
DIST00 BETWEEN 2PT
207.0 PIXEL OK
ST-PNT 00(259.0, 178.0)
ST-PNT 01(466.0, 178.0)
DIST01[BETWEEN Y
50.0 PIXEL OK
ST-PNT 00(259.0, 178.0)
ST-PNT 02(361.0, 228.0)
X0~6 Y0~7
: :
MSR-CHNG REG-CHNG PC-MONTR SET-SCRN MANL-TYP-CHG
ANGL00[3PT-ANGL]
88.2 OK
ST-PNT00(259.0, 178.0)
ST-PNT01(466.0, 178.0)
ST-PNT02(361.0, 228.0)
ANGL01[2PT-ANGL(HORI)]
03.5 OK
ST-PNT00(259.0, 178.0)
ST-PNT02(361.0, 228.0)
9-70
F L C1ALLC2NO
VX.X
BUSY
: