Copying (Editing) - Sharp IV-S20 User Manual

Shared settings

[7] Copying (editing)

When there are many common parameters between measurement programs or object types, it is
most efficient to access those existing sets of parameters in order to copy and then modify them.
- There are two types of copy functions on the IV-S20: Copying between object types and copying
between measurement programs.
(1) Copying between object types
The parameters of a previously specified object type are copied into another object type, after
which they can be modified.
The measurement conditions of
the source object type. (The data
is copied from flash memory)
[Operation procedure]
On the MAIN OPS MENU, move the cursor to SET-SCRN item, and press the SET key.
9
1. Select item 1 OBJECT TYPE NO., using the up and down keys and press SET key.
2. Using the up and down keys, enter the object type number (00 to 15) for the target of the copy.
3. Select item 2 EDIT, using the up and down keys and press SET key.
4. Move the cursor to COPY (copying) using the left and right keys and enter the object type
number (00 to 15) for the source of the copy using the up and down keys. When the number
has been selected, press SET key.
- While something is being copied, the message [COPYING] will appear at the top of the
Notes
- Do not disconnect the power while the IV-S20 is copying.
- Once data has been corrupted it will be necessary to start after initializing the setting, all over
again. Unless this is done it will not be possible to restart the machine.
- The reference images used for the gray scale seach function are not copied with the
operation above. Make sure reset them.
The source of the copy
- On the [SYSTEM SETUP] menu, move the cursor to 2 OBJECT TYPE COND
(condition of object type) and press the SET key.
[OBJECT TYPE COND]
1OBJECT TYPE NO.
2EDIT
1
3TITLE REGISTRATION (TO NEXT SUB-MENU)
3
4MEAS.0, CAMERA1
5POS. ADJ.CAMERA1
6MEAS.0, CAMERA2
7POS. ADJ.CAMERA2
8SELECT CAMERA IMG NO CAM1 CAM1 CAM1&2
9COMPARE IMAGES
0MEASUREMENT 1
qMEASUREMENT 2
wMEASUREMENT 3
eFINAL CALC RESULT
rFINAL OUTPUT COND (TO NEXT SUB-MENU)
tSYSTEM-IN/OUT
yHALT MEAS ON NG
uUPPER MENU
· Item 9 COMPARE IMAGES (calculation between
images) will be displayed unless item 8 SELECT
CAMERA IMG is set to NO.
screen. This message will disappear when the copying is complete.
The target of the copy
The measurement conditions of the target
object type. (The data is used to simplify
setting the target object's parameters)
2
00(0~15)
COPY( TYPE00) INITIALIZE
NO (TO NEXT SUB-MENU)
NO ADJ. [REG. 0-1PNTSXY
NO (TO NEXT SUB-MENU)
NO ADJ. [REG. 0-1PNTSXY
NO SUB.I1 T1 DIFF.ABS I1 T1
NO (TO NEXT SUB-MENU)
NO (TO NEXT SUB-MENU)
NO (TO NEXT SUB-MENU)
(TO NEXT SUB-MENU)
(TO NEXT SUB-MENU)
NO YES
9-28
4