Table of Contents
Advertisement
From the previous page
Select item 0 MEASUREMENT 1, q MEASUREMENT 2 or w MEASUREMENT 3, on the
[OBJECT TYPE COND] (conditions of object type) menu.
[TYPE00-MEAS1]
1MEAS SELECTION NO
2COMPARE IMAGES NO YES(CAM1)
1
3SELECT CAMERA CAM1 CAM2
4COPY
2
5INITIALIZATION
6MEAS.PROG. COND (TO NEXT SUB-MENU)
7EVALUATION COND (TO NEXT SUB-MENU)
8NUMERIC CALC COND (TO NEXT SUB-MENU)
9OUTPUT CONDITIONS (TO NEXT SUB-MENU)
0UPPER MENU
1. Using the up and down keys, select item 2 COMPARE IMAGES (calculation between
images).
2. Select "YES" (enable calculation) using the left and right keys.
-This will display the results of the comparative calculations between images.
Then, item 3 SELECT CAMERA will disappear.
With this the settings concerning comparative calculations between images are complete.
CHECK-DEG-OF-MATCH
DST&AGL MES. (GRAY&EDGE GRAV)
INSPECT-LEAD MEASR-BIN-AREA
CNT-BIN-OBJ LABEL-BIN-OBJ
POINT MEAS
EXEC TYPE00 MEAS1 NO
EXEC
9-27
This indicates that the display is for object type
00 and measurement 1.
This indicates that the selected measurement
program is the MEASR-BIN-AREA (area meas-
urement by binary coversion).
This refers to the camera which has been select-
ed in item 8 SELECT CAMERA IMG (camera
selection), on the [OBJECT TYPE COND] (con-
dition of object type) menu.
Shared settings
9
Advertisement
Table of Contents
