Pc Monitor Screen - Sharp IV-S20 User Manual

PC Function

10-5 PC monitor screen

On the MAIN OPS MENU, move the cursor to PC-MONTR item, on the menu bar at the bottom of
the screen, and press the SET key. Then, the PC monitor screen will be displayed.
(TYPE00) AREA1
OK
MEAS. XXXXXXms
1
2
3
C000 007
4
[TMR]
TM0 250
5
TM1
TM2
6
TM3
TM4
TM5
TM6
TM7
7
OUT-CHNG AUX-CHNG NUM-CHNG RUN-SCRN MANL-TYP-CHG
1 The ON ( ) or OFF ( ) status of the input relays (X00 to X06) is displayed.
2 The ON ( ) or OFF ( ) status of the output relays (Y00 to Y15) is displayed.
3 The ON ( ) or OFF ( ) status of the auxiliary relays (C000 to C127) is displayed.
4 The current timer value is displayed.
5 The current counter value is displayed.
6 The results (AN00 to AN15) of the final numerical calculations are displayed.
7 Menu bar
Menu bar
10
OUT-CHNG
AUX-CHNG
NUM-
CHNG
RUN-SCRN Press the SET key to return to the MAIN OPS MENU.
MANL-
TYP-CHG
The other data displayed is the same as on the MAIN OPS MENU. (See page 7·2.)
C112
X00 06
BUSY
Y00 07
[CNT] [FIAL NUMERIC CALC]
CN0 060 AN00= 00008600.0
CN1 AN01=
CN2 AN02=
CN3 AN03=
CN4 AN04=
CN5 AN05=
CN6 AN06=
CN7 AN07=
Change the output relay address (Y00 to Y15) with the up and down keys (in units of
8 points).
Change the auxiliary relay address (C000 to C127) with the up and down keys (in
units of 8 points).
Change the final numerical calculation address (AN00 to AN15) with the up and
down keys (in units of 8 points).
Manually change the object type number (00 to 15) with the up and down keys.
· The object type number can be changed by setting the OBJ. NO. MANL MODE item
to YES. (See page 8·9.)
· The image will be cleared every time the object type is changed. (However, when
the CAPTURE AN IMAGE item has been set to "NO," the image will not be cleared.)
F L C1ALLC2NO
VX.X
C1=002.2 OK
C2=100.0 OK
Description
10-16
Select BUSY or READY
on the [I/O SETTINGS]
menu.