Table of Contents
Advertisement
[2] Installing and connecting the IV-S30C1
(1) Connections
Up to two IV-S30C1 cameras can be connected to the IV-S20 main housing using the IV-S20HC3
camera conversion cable.
Camera 2 connector: CAMERA2
Camera 1 connector: CAMERA 1
3
Camera 1
Camera conversion
Camera
cable (IV-S20HC3)
(IV-S30C1)
Camera 2
1 Connect the IV-S20HC3 camera cable(s) to the CAMERA 1 and CAMERA 2 connectors on the
IV-S20 main housing.
Note: Only connect or disconnect the camera connectors while the power is OFF.
- Push the convex side of the connector into the concave side of the mating connector. When the
connector is all the way on, it clicks.
- To disconnect the connector, hold the plug of the connector, and pull it straight out.
- A camera connected to the camera 1 connector (CAMERA1) is treated as camera 1 by IV-S20
system, and a camera connected to the camera 2 connector (CAMERA2) is treated as camera
2.
Note: You must have a camera connected to the camera 1 connector.
- The IV-S20HC3 camera cable is 3m long. If you need a longer cable, order extension camera
cable IV-S20EC2 (cable length 2m) or IV-S20EC4 (cable length 4m).
2 Plug the other end of the IV-S20HC3 camera conversion cable into the IV-S30C1, and tighten the
securing ring on the plug housing.
3 Screw the IV-S20L16 camera lens (or similar) into the lens holder on the IV-S30C1until it is
secure.
-
2
Connector
Camera lens
(IV-S20L16 or similar)
6- 23
Installation Conditions and Method
IV-S20 main housing
(side view)
1
Plug
1
Extension camera cable IV-S20EC2/4
Camera connector of
IV-S20 main housing
Lens holder
IV-S30C1
6
Advertisement
Table of Contents
