Table of Contents
Advertisement
Counting quantities by binary convension
[2] Setting details
An explanation of 6 MEAS.PROG.COND (conditions for measurement programs) from the
[TYPE00-MEAS1 to 3] (object type measurement) menu.
On the MAIN OPS MENU, move the cursor to SET-SCRN, and press SET key.
-On the [SYSTEM SETUP] menu, move the cursor to 2 OBJECT TYPE COND (conditions of
object type) and press the SET key.
-Select item 0 MEASUREMENT 1, q MEASUREMENT 2 or, w MEASUREMENT 3 on
the [OBJET TYPE COND] menu .
Select item 6 MEAS.PROG.COND (conditions for measurement programs).
9
Select item 2 BINARY AREA COND (conditions for binary areas).
Continued on the following page
[TYPE00-MEAS1]
1MEAS SELECTION
2COMPARE IMAGES NO YES(CAM1)
3SELECT CAMERA
4COPY
5INITIALIZATION
6MEAS.PROG. COND (TO NEXT SUB-MENU)
7EVALUATION COND (TO NEXT SUB-MENU)
8NUMERIC CALC COND (TO NEXT SUB-MENU)
9OUTPUT CONDITIONS (TO NEXT SUB-MENU)
0UPPER MENU
- In item 1, select CNT-BIN-OBJ (measure the area of binary images).
- Item 2 will be displayed unless NO is selected in item 8 SELECT CAMERA
IMG (camera selection) which is in the [OBJECT TYPE COND] menu.
[MEASURING COND] (TYPE00-MEAS.1-CNT-BIN-OBJ)
1REGST NO.
00(0~ ) REG.NO YES
2BINARY AREA COND (TO NEXT SUB-MENU)
3UPPER MENU
- If YES is specified in item 1 REGST NO. (registration number), then item 2 will be
displayed.
Measurement conditions
1REGST NO.
(registration number)
2BINARY AREA COND
(conditions for binary areas)
3UPPER MENU
NO
CHECK-DEG-OF-MATCH
DST&AGL MES. (GRAY&EDGE GRAV
INSPECT-LEAD MEASR-BIN-AREA
CNT-BIN-OBJ LABEL-BIN-OBJ
POINT MEAS
CAM1 CAM2
EXEC TYPE00 MEAS1 NO
EXEC
Setting details
Set this to any number from 0 to 3 and select NO or YES
to store it.
The conditions for binary areas are set on the next
menu.
This will return you to the [TYPE00-MEAS1 to 3] menu.
9-92
This is how the line looks
when the object type is set
to 00 and the selected
measurement is 1.
Advertisement
Table of Contents
