Table of Contents
Advertisement
Shared settings
(2) Final numerical calculations
Final numerical calculations can be set at item e FINAL CALC RESULT on the conditions of
object types menu [OBJECT TYPE COND].
The setting procedure, error output settings, calculation sequence and parallel output based on
the output conditions are exactly the same as those used for item (1) individual numerical
calculations for each measuring programs.
On the MAIN OPS MENU, move the cursor to SET-SCRN and press the SET key.
-On the [SYSTEM SETUP] menu, move the cursor to 2OBJECT TYPE COND (conditions of
object type) and press the SET key.
-On the [OBJECT TYPE COND] menu, move the cursor to eFINAL CALC RESULT (final
numeric calculation) and press SET key.
[NUMERIC CALC] (TYPE00)
1CALC. RESULT AN00(0~15)
2OBJECT TYPE NO INDV-MEAS-RSLT[N] FINAL-RESULT[AN]
3FORMULA
4UPPER&LOWER LIMIT 00000000.0~ 00000000.0
5OUTPUT
6RUN A TEST
7UPPER MENU
9
Numerical calculation
1 CALC.RESULT
2 OBJECT TYPE
3 FORMULA
(registaration number)
4 UPPER&LOWER LIMIT
5 OUTPUT
6 RUN A TEST
7 UPPER MENU
NUM-CALC[NC] CNST[C]
MEAS0(0~3) CMR1(1~2) N00(0~15)
+-
/
NO Y0(0~7) C000(0~107)
(SET KEY)
01N00+02N00+3N01
N00
[N]
+00009800.0~ +00010000.0
N01
N02
N03
· The display areas on the screen are in the same places as those for item (1) individual
numerical calculations for each measuring program.
The location where the rule 4 calculation result of the specified output data is
stored may be set from 00 to 15.
Select the type of data being calculated.
A number of style settings are used.
The first line will change according to the selection made in item 2.
Selection of 2
Calculation results for
measurements [N]
Final calculation results [AN]
Numerical calculations [NC]
Constant [C]
Note: Please use a smaller number for entering numbers at AN (00 to 15)
than that 1 CALC. RESULT (calculations results) AN (00 to 15).
Enter the upper and lower limits for making a decision.
Setting the output of the calculation results.
Pressing the SET key will record the setting details as well as run a test.
This will return you to the [OBJECT TYPE COND] (conditions of object type)
DEL. END
00009800.0
Setting details
Measurement 0 (0 to 3) camera 1 (1 to 2)
N00 (0 to 15)
AN00 (0 to 15)
ABS
(the second line will not be displayed)
+00000000.0
(the second line will not be displayed)
9-18
Example:
[Results of the calculations
for measurement 0, camera
1: N00] + [Results of the
Y1
calculations for
measurement 0, camera 2:
OK
N00] + [Results of the
calculations for
measurement 3: N01]
The first line of the display
TAN ATAN AN00 (0 to 15)
Advertisement
Table of Contents
