User's Manual
Parameter
MAX Incoming ANI Digits
[CasStateMachineMaxNumOfInc
omingANIDigits]
Collet ANI
[CasStateMachineCollectANI]
Digit Signaling System
[CasStateMachineDigitSignaling
System]
22.4
Configuring Digital Gateway Parameters
The Digital Gateway Parameters page allows you to configure miscellaneous digital
parameters. For a description of these parameters, see 'Configuration Parameters
Reference' on page 1055.
To configure the digital gateway parameters:
1.
Open the Digital Gateway Settings page (Setup menu > Signaling & Media tab >
Gateway folder > Digital Gateway > Digital Gateway Settings).
2.
Configure the parameters as required.
3.
Click Apply.
Version 7.2
Defines the limitation for the maximum ANI digits that need to be
collected. After reaching this number of digits, the collection of
ANI digits is stopped.
The value must be an integer. The default is -1 (use value from
CAS state machine).
In some cases, when the state machine handles the ANI
collection (not related to MFCR2), you can control the state
machine to collect ANI or discard ANI.
[0] No = Don't collect ANI.
[1] Yes = Collect ANI.
[-1] Default = Default value - use value from CAS state
machine.
Defines which Signaling System to use in both directions
(detection\generation).
[0] DTMF = Uses DTMF signaling.
[1] MF = Uses MF signaling (default).
[-1] Default = Default value - use value from CAS state
machine.
Figure 22-4: Digital Gateway Parameters Page
Description
499
Mediant 800B Gateway & E-SBC
22. Digital PSTN