Components (Rear); Figure 1.8 Controller (Eternus Dx500 S3) - Fujitsu ETERNUS DX600 S3 Basic Operation Manual

Chapter 1 Component Name/LED Name
1.1 Controller Enclosures
1.1.4

Components (Rear)

This section describes the controllers and the power supply units in the rear of the controller enclosure.
■
Controller
The controller contains a CPU, cache memory, host interfaces, Bootup and Utility Device (BUD), and drive in-
terface (DI) ports. The controller controls all operations in the ETERNUS DX.
●
Controller (ETERNUS DX500 S3)
Figure 1.8 shows the controller of the ETERNUS DX500 S3.

Figure 1.8 Controller (ETERNUS DX500 S3)

1
1. Host interface (CA#0)
Install host interfaces.
2. Host interface (CA#1)
Install host interfaces.
3. LAN (FST) port
A port that is dedicated for maintenance engineers. Customers must not use this port.
4. LAN (RMT) port
These are the RJ-45 connectors to connect LAN cables.
5. LAN (MNT) port
These are the RJ-45 connectors to connect LAN cables.
6. DI (OUT) port
This port is used to connect a controller enclosure to a drive enclosure with a cable between enclosures.
7. PWC port
This port is used to connect a power synchronized unit with an RS232C cable.
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Operation Guide (Basic)
3 4 5 6
Copyright 2014 FUJITSU LIMITED
7
18
2
P3AM-7742-04ENZ0