Removing And Replacing A Tape Drive; Figure 5.1 Drive Sled Components Of Rear Pane - Fujitsu P3AM-5382-03ENZ0 Installing, Starting Up And Maintaining

Chapter 5 Servicing

5.3 Removing and Replacing a Tape Drive

5.3 Removing and Replacing a Tape Drive
The tape drive is installed at the back of the library.
To remove a tape drive:
Procedure
1
Using your Remote Management Unit or the Operator Control Panel, unload the tape
cartridge from the drive to be removed.

Figure 5.1 Drive sled components of rear pane

Steps
1
2
3
6
Before pulling the drive sled out, please pull forward the product ID tag located below the drive sled
(see Figure 5.2
2
Pull straight back on the tape drive handle to remove it from the library. Take care to slightly
push down the product ID slide so it does not interfere with the drive sled (see
FUJITSU Storage ETERNUS LT20 S2 LTO Library Installing, Starting Up and Maintaining
Power down the library using the power button on the front pan.
The LED on the tape drive is off.
Remove the power cable and signal cable(s) from the tape drive.
Loosen the captive thumbscrews on the drive.
detail 1). Otherwise the slide or the attached label could be damaged.
81
Copyright 2014 FUJITSU LIMITED
Description
Figure 5.2).
P3AM-5382-03ENZ0