Eternus Dx60 S4 Components (Rear); Figure 10 Controllers; Table 2 Status And Meanings Of Each Led (Drive (Controller Enclosure)) - Fujitsu ETERNUS DX60 S3 Operation Manual

1. Component Names and LED Names
Controller Enclosures
The LEDs turn on or blink to indicate the statuses that are listed below.

Table 2 Status and Meanings of Each LED (Drive (Controller Enclosure))

LED name
DRIVE READY
DRIVE FAULT

ETERNUS DX60 S4 Components (Rear)

This section describes the controllers and the power supply units in the rear of the controller enclosure for the
ETERNUS DX60 S4.
■
Controllers
The controller contains a CPU, system memory, Battery Backup Unit (BBU), host interfaces, drive interface (DI)
ports, and LAN ports. The controller controls all operations in the ETERNUS DX.
Controllers (FC, iSCSI 10Gbit/s, iSCSI 1Gbit/s, SAS 12Gbit/s, and SAS 6Gbit/s) are available for different types of
host interfaces.
Figure 10 shows the controller.

Figure 10 Controllers

1
14 15
FC
19 19
6 7
1. PWC port
This port is used to connect a power synchronization unit with an RS232C cable.
FUJITSU Storage ETERNUS DX60 S4, ETERNUS DX60 S3 Hybrid Storage Systems Operation Guide (Basic)
LED status
(green)
(blinks green)
(amber)
Table 3 shows the status and meanings of each LED.
2 3 4
16 16 18
17 17
iSCSI 1Gbit/s iSCSI 10Gbit/s
8 9 8
20
20 20
21
21 21
14
Copyright 2018 FUJITSU LIMITED
Meaning
The drive is in normal status.
The drive is in error status.
•
The LED light up operation was performed from the ETERNUS
•
CLI command line in order to identify the drive location.
5
22 23
SAS 6Gbit/s
19 19
10 11
9
20
21
SAS 12Gbit/s
19 19
12 13
P3AM-9012-08ENZ0