Components (Rear); Figure 1.10 Controllers; Table 1.2 Status And Meanings Of Each Led (Drive (Controller Enclosure)) - Fujitsu ETERNUS DX60 S3 Operating Instructions Manual

Chapter 1 Component Name/LED Name
1.1 Controller Enclosures
The LEDs turn on or blink to indicate the statuses that are listed below.

Table 1.2 Status and Meanings of Each LED (Drive (Controller Enclosure))

LED name
DRIVE READY
DRIVE FAULT
1.1.4

Components (Rear)

This section describes the controllers and the power supply units in the rear of the controller enclosure.
■
Controllers
The controller contains a CPU, cache memory, System Capacitor Unit (SCU), host interfaces, drive interface
(DI) ports, and LAN ports. The controller controls all operations in the ETERNUS DX.
Controllers (FC, iSCSI, and SAS) are available for different types of host interfaces.
Figure 1.10 shows the controller.

Figure 1.10 Controllers

1
1. PWC port
This port is used to connect a power synchronization unit with an RS232C cable.
LED status
(green)
(blinks green)
(amber)
Table 1.3
2 3 4
12 13 14 14 16
15 15
FC
17 17
6 7
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Operation Guide (Basic)
Copyright 2014 FUJITSU LIMITED
Meaning
The drive is in normal status.
The drive is in error status.
•
In response to commands from ETERNUS CLI, the location of
•
the drive is identified.
shows the status and meanings of each LED.
5
20 21
iSCSI
8 9
18 18
19 19
18
SAS
17 17
10 11
P3AM-9012-01ENZ0