Components (Rear); Figure 1.11 Controller; Table 1.2 Status And Meanings Of Each Led (Drive) - Fujitsu ETERNUS DX80 S2 User Manual

Chapter 1 Components
1.1 Controller Enclosure
●
Part explanation
• LEDs
The states of LEDs are listed below.
Table 1.2
LED name
DRIVE READY
DRIVE FAULT
1.1.4

Components (Rear)

This section describes the controllers and the power supply units in the rear of the controller enclosure.
1.1.4.1 Controllers
The controller contains a CPU, cache memory, System Capacitor Unit (SCU), host interfaces, drive interface (DI)
ports, and LAN ports. The controller controls all operations in the ETERNUS DX Disk storage system.

Figure 1.11 Controller

DI (OUT) LINKUP LED
DI (OUT) port
CA#0 FAULT LED
UNIT ID LED
PWC port
LINK/FAULT LEDs
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Operation-
Status and meanings of each LED (drive)
LED status
(green)
(blinks green)
(amber)
Host interface (CA#0)
Copyright 2013 FUJITSU LIMITED
The drive is in normal status.
•
The drive is in error status.
•
In response to commands from ETERNUS CLI, the location of
the drive is identified.
LAN (RMT) port
READY/FAULT LED
CA#1 FAULT LED
MASTER LED
LAN (MNT) port
ACT LEDs
LINK LEDs
Host interface (CA#1)
17
Drive status
P3AM-4842-12ENZ0