Components (Rear); Figure 1.12 Controller (Fc Model) - Fujitsu Eternus DX60 S2 User Manual

Chapter 1 Components
1.1 Controller Enclosure
●
Part explanation
• LEDs
The states of LEDs are listed below.
Table 1.3
DISK READY/
FAULT
1.1.4

Components (Rear)

This section describes the controllers and the power supply units in the rear of the controller
enclosure.
1.1.4.1 Controllers
The controller contains a CPU, cache memory, System Capacitor Unit (SCU), non-volatile mem-
ory, host interface adapters, drive interface (DI) ports, and LAN ports.
The controller controls all operations in the ETERNUS DX Disk storage system.
■
FC model

Figure 1.12 Controller (FC model)

ETERNUS DX60 S2 Disk storage system User's Guide -Operation-
Status and meanings of each LED (3.5" disks)
LED name LED status
(green)
(blinks green)
(orange)
(blinks orange)
SCU STATUS LED
IDENTIFY LED
DI (OUT) LINKUP LED
LAN (RMT) port
LAN (MNT) port
ACT LED
LINK LED
DI (OUT) port
Copyright 2011 FUJITSU LIMITED
The disk is operating normally.
The disk is in error status.
In response to commands from Microsoft Virtual Disk
Service (VDS), the location of the disk is identified.
FC LINKUP/FAULT LED
FC port (0 (Left), 1 (Right))
UNIT READY/FAULT LED
MASTER LED
PWC port
16
Disk status
P3AM-5512-02ENZ0