Hard Disk Drives / Solid State Drives - Fujitsu Server PRIMERGY TX1330 M1 Upgrade And Maintenance Manual

7 Hard disk drives / solid state
drives
Safety notes
V
CAUTION!
The hard disk drive must not be removed from the installation frame
●
by anyone except a service technician.
HDD / SSD modules must all be marked clearly so that they can be
●
reinstalled into their original mounting locations after an upgrade.
Otherwise, data may be lost.
Do not touch the circuitry on boards or soldered parts. Hold the
●
metallic areas or the edges of the circuit boards.
Before removing a hard disk drive, wait for about 30 seconds until the
●
disk has stopped spinning completely.
When a hard disk drive is starting up, a resonant noise may be
●
audible for a short while. This does not indicate a failure.
Depending on the OS, you can configure the write cache settings for
●
the hard disk drives. If a power failure should occur while the write
cache is enabled, cached data may be lost.
When disposing of, transferring, or returning a hard disk or solid state
●
drive, wipe out the data on the drive for your own security.
Rough handling of hard disk drives may damage the stored data. To
●
cope with any unexpected problems, always back up important data.
When backing up data to another hard disk drive, you should make
backups on a file or partition basis.
Handle the device on a shock and vibration free surface.
●
Do not use the device in extremely hot or cold locations, or locations
●
with extreme temperature changes.
Never attempt to disassemble a hard disk or solid state drive.
●
For further safety information, please refer to chapter
●
information" on page
TX1330 M1
31.
Upgrade and Maintenance Manual
"Important
121