Removing A Bbu; Preliminary Steps; Disconnecting The Bbu Cable From The Controller; Removing The Bbu Holder From The Chassis - Fujitsu Server PRIMERGY TX1330 M1 Upgrade And Maintenance Manual

Expansion cards and backup units
9.5.5

Removing a BBU

Upgrade and Repair Unit
(URU)
Tools: tool-less
V
CAUTION!
Do not throw battery backup units into the trash can. Batteries must be
disposed of in accordance with local regulations concerning special
waste.
For further safety information, please refer to section
protection" on page
9.5.5.1

Preliminary steps

"Shutting down the server" on page 46
Ê
"Disconnecting the server from the mains" on page 46
Ê
"Getting access to the component" on page 47
Ê
"Removing the fan module" on page 151
Ê
9.5.5.2

Disconnecting the BBU cable from the controller

Ê Carefully disconnect the BBU cable from the RAID controller.
9.5.5.3

Removing the BBU holder from the chassis

Ê Remove the BBU holder from the chassis as described in section
"Removing the FBU holder from the chassis" on page
9.5.5.4

Concluding steps

"Installing the fan module" on page 152
Ê
"Reassembling" on page 58
Ê
"Connecting the server to the mains" on page 67
Ê
"Switching on the server" on page 68
Ê
202
41.
Upgrade and Maintenance Manual
Hardware: 5 minutes
"Environmental
201.
TX1330 M1