Expansion cards and backup units
Ê If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
I
Configuration of network settings should be performed by the
customer.
For further information, please refer to section
settings recovery" on page
Ê If applicable,
"After replacing / upgrading LAN controllers" on page 94
9.4.4
Replacing the riser card
Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver
9.4.4.1
Preliminary steps
"Locating the defective server" on page 43
Ê
"Disabling BitLocker functionality" on page 69
Ê
"Shutting down the server" on page 46
Ê
"Disconnecting the server from the mains" on page 46
Ê
Ê Remove all external cables from the expansion card installed in the riser
card slot.
"Getting access to the component" on page 47
Ê
"Removing the fan module" on page 151
Ê
9.4.4.2
Removing the defective riser card
Ê Remove the expansion card from the riser card slot as described in section
"Removing an expansion card" on page
184
182.
Upgrade and Maintenance Manual
"Note on network
Hardware: 5 minutes
180.
TX1330 M1
Need help?
Do you have a question about the Server PRIMERGY TX1330 M1 and is the answer not in the manual?